Skip to main content
Pipe Verdict
How-To GuidesDemo Template Post

How to Press Copper Pipe with a ProPress Tool: Step by Step for Beginners

Step-by-step demo how-to guide covering cutting, deburring, insertion depth marking, jaw alignment, and safety checks when pressing copper pipe.

Pipe Verdict Editorial TeamUpdated 2 min read
Share:RedditFacebook
Demo placeholder illustration showing step-by-step copper pipe pressing with a ProPress tool
Demo placeholder image — replace with verified step photography in R2.
Table of Contents

[Demo Content Placeholder] Pressing copper fittings is fast and flame-free, but skipped prep work—especially failing to deburr or mark insertion depth—causes leaks. Follow this step-by-step How-To template.

Tools and Materials Needed

  • ProPress tool with size-matched copper press jaws (e.g., 1/2" or 3/4")
  • Copper tubing cutter (clean square cut—avoid hacksaws where possible)
  • Inside/outside copper deburring & reaming tool
  • Permanent marker and insertion-depth gauge (or tape measure)
  • Safety glasses and clean rag

Step-by-Step Instructions

1

Step 1

Shut Off Water and Make a Square Cut

Shut off the water supply, relieve line pressure, and cut the copper tube squarely with a rotary tubing cutter. Inspect the pipe end to ensure it is round and free of deep scratches.

2

Step 2

Deburr Both Inside and Outside Edges Thoroughly

Use a deburring tool to remove sharp inner and outer burrs. Smooth outer edges prevent cutting or dislodging the rubber EPDM O-ring seated inside the press fitting.

Safety / Common Mistake: Skipping outer deburring is the #1 beginner mistake—a nicked EPDM O-ring can leak immediately or fail under pressure later.
3

Step 3

Inspect the O-Ring and Mark Full Insertion Depth

Visually confirm the rubber sealing element is properly seated inside the fitting. Mark the manufacturer-specified insertion depth on the copper pipe with a permanent marker, then slide the fitting on until it reaches your mark.

4

Step 4

Align the Press Jaws Squarely and Complete the Press Cycle

Open the rated press jaw, seat its groove squarely over the raised bead of the fitting at a 90-degree angle to the pipe, keep fingers clear of the jaw, and hold the trigger until the automatic press cycle completes and releases.

Safety / Common Mistake: Keep hands and fingers completely clear of the press jaws during actuation—hydraulic press tools exert several tons of force.

Frequently Asked Questions

Do I need flux or solder when using a ProPress tool?
No. ProPress creates a mechanical compression seal around an internal EPDM O-ring—never apply flux or heat to a press fitting.
Why do I have to mark insertion depth on the pipe?
The depth mark lets you verify visually right before and after pressing that the pipe did not slip partway out of the fitting.
Can a pressed copper fitting be reused if I make a mistake?
No. Once pressed, the copper fitting is permanently deformed and must be cut out and replaced with a new fitting.
Topics:Copper PipeHow-To GuidesPress Tools

Editorial Standard

Pipe Verdict Editorial Team

Pipe Verdict focuses exclusively on physical plumbing tools for US and Canadian plumbers and homeowners. We never invent prices, star ratings, or hands-on test claims, and we always list honest drawbacks alongside our recommendations.

Explore all How-To Guides →